![]() Inset the card to Raspberry Pi and power on it. Note: you need to change your_real_wifi_ssid and your_real_password" to the real ssid and password.ģ. (if you didn't find the files, create them.) ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev Add the following lines to wpa_nf files in the BOOT directory. Download the pre-configured image and write it to your TF card.Ģ. The pre-configured images have already installed the required libraries and drivers, and the program runs automatically after booting. It is recommended to install pre-configured images for newbies or first-time installations. ![]() The second method is to configure the environment running the program on the original image of the Raspberry Pi. Method one, using a pre-configured mirror. If you want to remove this error, remove otg_mode=1 in of config.txt, and add dtoverlay=dwc2, dr_mode=host (USB cannot be recognized without adding it). If you use the latest Raspberry Pi OS (image after October 30, 2021) USB2.0 is OTG mode by default, and CM4 will report an error:Ĭonfig failed, hub doesn't have any ports! (err -19) If you need to start, you need to add the following demo to the config.txt file: The USB port is disabled by default on the CM4 to save power.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |